How Much Does Installation Of Tile Cost in Akron?

Last updated

Crews serving Akron quote installation of tile anywhere from $2,001 to $7,805 per job; the middle of the pack is about $3,952.

Demand in Akron swings with the season, and Ohio weather can push installation of tile prices higher during busy stretches. Off-peak scheduling often costs less.

Typical cost at a glance

United States planning figures, per job
LevelPrice
Low~$2,001
Typical~$3,952
High~$7,805

Cost by type

TypeLowTypicalHigh
Complete installation of tile at standard grade~$2,001~$4,903~$7,805
Single-issue patch or repair~$360~$1,585~$2,810
Assessment visit with written scope~$60.00~$264~$468
Upgraded materials or custom finish~$3,102~$9,747~$16,391
Weekend, holiday or rush callout~$2,561~$7,603~$12,644

All figures per job.

Timing your installation of tile

Scheduling matters as much as the quote for installation of tile. Emergency and same-week work carries a premium, while a planned slot booked ahead usually lands closer to the middle of the range.

How to compare quotes for installation of tile

Line the installation of tile quotes up side by side and ask what changes the price after acceptance. That one question exposes most of the gap between the $2,001 low end and the $7,805 high end.

Budgeting for installation of tile

Start your installation of tile budget at $3,952 per job and adjust once you have written quotes. Planning around the midpoint, not the minimum, avoids unpleasant surprises.

What moves the price of installation of tile

Scope is the biggest lever on installation of tile pricing. Ask what is included and what is not, then compare the same job across providers. A wider scope at a lower rate can still cost more than a narrow scope at a higher one.

What Installation Of Tile typically costs

When you price out installation of tile in Akron, keep the $2,001 to $7,805 per job range in mind. Anything far below $2,001 usually means a narrower scope than you asked for; anything above $7,805 usually adds premium materials or urgent scheduling.

Who sets installation of tile prices

Ask who sets the price of installation of tile and the honest answer is the provider, job by job. Their costs and capacity decide whether you see something near $2,001 or nearer $7,805.

Frequently asked questions

How much does installation of tile cost?
Most installation of tile falls between $2,001 and $7,805, with a typical figure near $3,952 per job. The low end is a straightforward job with no surprises; the high end covers complex scope, premium materials or urgent timing. Where you are in Akron can change the detail, so compare nearby quotes.
What affects the price of installation of tile?
The honest answer is that it depends on the specifics. Compare the written scope first, then the price. The specifics vary across Akron, so confirm them with the provider you hire.
Is Installation Of Tile cheaper in smaller cities?
Often, but not always. Smaller markets can carry a travel or availability premium that offsets a lower local rate, so it is worth checking a nearby city before assuming the lowest published figure applies to you. For Akron, ask a provider to put that in writing with the quote.
How many quotes should I get for installation of tile?
Two or three written quotes are enough to see the real market range. Compare the same scope side by side, and ask each provider what is excluded and what would change the price after the quote is accepted. Providers serving Akron can tell you how it affects a typical job.

Keep comparing

Related categories

Related costs

Cities in this region

These are planning ranges drawn from public price data and market research. They are not a quote, an offer or financial advice, and your actual price depends on the provider, the location and the scope of the work.